The SG Radiant Oscillator

[Faraday88]

Hi John,
i have tested my Full-Regauge version of the Solid-State Radiant Oscillator charger...
it cold -boils the receive battery in 30 min.. and i have swapped the two battries 8 times now... the two battries balance out their Impedance and with same standing voltage when the secondary battery no longer increasses in charge.
is this the Real Mc'coy counterpart...
rgds,
Faraday88.

[Faraday88]

Hi ,
The twist direction does not matter because it is relative to the two wires as uniform capacitance and Inductance is achived either ways.
Rgds,
Faraday88.

[Faraday88]

Hi John,

Amoung the two primaries, can the other be called as the 'Recovery coil'..?
is'nt the split Diodes a half of a Bridge-Module, if a complete bridge is used i guess we are doing a Full Regauge Charger.

Rgds,
Faraday88.

[Faraday88]

Hi John,

Amoung the two primaries, can the other be called as the 'Recovery coil'..?
is'nt the split Diodes a half of a Bridge-bridge, if a complete bridge is used i guess we are doing a Full Regauge Charger.

Rgds,
Faraday88.

[Faraday88]

Hi John,
Thanks for your valuablel inputs, it was like i studied PHD and comming in the reverse order to have forgotten the fundamentals although this has shed some essesntial Complementary parameters on the two modes of charging..!
the world that followed the conventional one and Bedini having figured it out to do it in the Radiant way...!
Hats of to Bedini and Tesla indeed.

Rgds,
Faraday88.

[min2oly]

min2oly,

so two primary and one trigger, correct? or 3 primary and one trigger (do not want to waster copper) ? also should the twist be going the same way as the wind on the coil?

thanks

John shows us in his vids http://www.energyscienceforum.com/sg....html#post1107
the twist direction should not matter although I have not made that experiment so anyone can chime in on this.
John is using 2 primaries in the vid. I believe he also has 2 triggers in parallel, however, he has not commented on this question as it came up...
notice the wave form.
kind regards,
Patrick

[John_Koorn]

Hi John,

Thanks for the information.
I have few more questions on the Radiant mode of charging the battery.
First, asume a fresh battery (dry) and then prepare by loading acidulated water (distilled water ofcourse) in it, and when this is done the
terminal Voltage reads 11.45V ect. next, Charge this Radiantly.it indicates Cold-Boiling with Terminall Voltage> 15V!! I have seen that the Radiantly Loaded Battries behave differently then the
ones which are Charged by Constant Current mode(conventional) of Charging (Non-Radiant mode).
We assume a brand new Battery bought of the shelf, those which are pre-charged are all of course Constant-Current Mode of Charge loaded in them.
Tell me, are those Machines(i mean all and not just the 10 coiler) which John bedini is running to charge the set of Battery bank are pre-Charged by Constant Current mode or are Charged by Radiant means right from when they were 'built'.
Thank you in advance.
Best Regards,
Faraday88.

Hi Faraday88,

All dry charged batteries are formed with constant current at the factory. They have to be formed this way no matter if radiantly or conventionally charged.

John K.

[nickle989]

min2oly,

so two primary and one trigger, correct? or 3 primary and one trigger (do not want to waster copper) ? also should the twist be going the same way as the wind on the coil?

thanks

[Faraday88]

Hi John,
I forgot to mention about my experiment with the two transistor version of the Radiant Oscillator using 2n3055 (Iron Cored coils), this is the expanded version of it single Transistor counterpart.
It showed Radiant 'High-Voltage' floating all over the system: at the Transistor pins, Battrey terminals, places where acid wetted the plastic parts of the Battery ect. I used a Neon Bulb to see this Float. and all this happen while it was Chariging a Healthy Battery (secondary).
Similar to what John shows in one of the EFTV dvds ...
Rgds,
Faraday88.

[Faraday88]

Hi Tom,
Thanks for chiming in here!!!!and the info on Graham gunderson.
I remember Tom bearden also mentions about anomolus 'Glow' found at the site where Sparky fell dead.
he mentions about sabotage on Sparky with Scalar weaponary (Venus Shooter Bazooka)....

Rgds,
Faraday88.

[Faraday88]

Hi John,

Thanks for the information.
I have few more questions on the Radiant mode of charging the battery.
First, asume a fresh battery (dry) and then prepare by loading acidulated water (distilled water ofcourse) in it, and when this is done the
terminal Voltage reads 11.45V ect. next, Charge this Radiantly.it indicates Cold-Boiling with Terminall Voltage> 15V!! I have seen that the Radiantly Loaded Battries behave differently then the
ones which are Charged by Constant Current mode(conventional) of Charging (Non-Radiant mode).
We assume a brand new Battery bought of the shelf, those which are pre-charged are all of course Constant-Current Mode of Charge loaded in them.
Tell me, are those Machines(i mean all and not just the 10 coiler) which John bedini is running to charge the set of Battery bank are pre-Charged by Constant Current mode or are Charged by Radiant means right from when they were 'built'.
Thank you in advance.
Best Regards,
Faraday88.

[John_Koorn]

Here are my Videos of Ralphs 6 coiler Superpole.

LED Strobe for 6 Coil Energizer Timing - YouTube

John K./Australia w/Ralphs 6 Coil Energizer - YouTube

Mike

Hey Mike, thanks for sharing. Your YT channel (kishbud) is awesome, you have some great stuff up there. It's going to take me a while to get through them all.

John K.

[Mike Kishline]

Here are my Videos of Ralphs 6 coiler Superpole.

LED Strobe for 6 Coil Energizer Timing - YouTube

John K./Australia w/Ralphs 6 Coil Energizer - YouTube

Mike

[Tom C]

Faraday88, there was guy at the conference (I don't remember his name) who had done some work with Barium Ferrite magnets to condition them. I only caught bits and pieces of the conversation so maybe someone else that was there can chime in with more info.

Regarding Ralph's machine, search this forum for user "trancedrum". That is Ralph and in one of his early posts he posted a link to a video of his machine - a 6 coiler superpole SSG with a COP>1.

John K.

that "guy" was Graham gunderson. do a google search of his name, plenty of stuff on his sweet VTA research. I will tell you this, that John B felt that the VTA is what killed sparky, as he did not understand the waves coming off the device.

Tom C

[John_Koorn]

Faraday88, there was guy at the conference (I don't remember his name) who had done some work with Barium Ferrite magnets to condition them. I only caught bits and pieces of the conversation so maybe someone else that was there can chime in with more info.

Regarding Ralph's machine, search this forum for user "trancedrum". That is Ralph and in one of his early posts he posted a link to a video of his machine - a 6 coiler superpole SSG with a COP>1.

John K.