Four Wave Mixing

[blackchisel97]

Thank you John. I have Arthesian well with small pond but need to get better microscope, preferably the one I can hook to the PC. I need this for other experiments as well. I'll post as soon as I get it done (hopefully next week).

Vtech

[John_Bedini]

Vtech,
I have now made the diagram available so the machine may be duplicated.
http://www.johnbedini.net/john34/medmachine010.jpg. this device looks simple, but it is not. It took a long time to adjust. I would use a microscope first with pond water. The resistor where the current meter is can be a small grain of wheat bulb at 12 volts. The bulb is in the circuit incase you short the leads. The audio transformer you can get from Radio Shack. The timer circuits should not use a Cmos 555's use the Texas Instruments
555's.

[blackchisel97]

Hi John. Thank you for sharing details. I'm working on Bob Beck device a.t.m and want to build this one as well.

Regards
Vtech

[John_Bedini]

Harlan Sanders,

The machine deals with Tom Bearden's Four Wave Mixing. The machine deals with a low frequency pump wave through a modulation transformer. The machine uses all Ne555 timers set to select frequencies Values for the first timer are as follows, The current through the electrodes must not exceed 50 Micro Amperes.
150 Ohms between pin 8 and 7
220K variable pot set for low freq square wave 50Cps between pin 7 and 6 pin 2 and 6 tied together The cap value .22Uf pin 1 to ground.

Other values are in the same arrangement.
IC Two. 150Cps
50 Ohms
50 K Variable
.022 Uf
IC Three 350 Cps
50 Ohms
50K Variable
0022 Uf
IC 4
680Ohms
100K
.047Uf
IC 5
680 Ohms
10K
.01 Uf
IC 6 Set to highest frequency.
680Ohms
250K Variable
.0039Uf
Pump Wave IC NE555 set between .8 to 8 Cps
Values 150 Ohms
1Meg Variable
2Uf
John
My Work on Rife