If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Anytime Kasper.. feel free to adjust with your need, but i stick to d43cm on the wheel as JB wheel size on the 10 coiler, and 20 superpole magnet...have a nice build
Yes, off course there is no pic here axxelxavier.. i put it on my Album, just click community, click Album, then you can search alfin superpole energizer folder..feel free if you have any question have a nice experiment...
Hallo everyone,
I've just upload my pic of superpole 10 coiler also with the blue print (been done the legworks) feel free to modify and adjust based on your need..btw, i've made that for about
plastic PE $67
Alum rotor(d430mm,32mm,7kg) $85
bolt and nut $20
1 alum profile 2020 $45
40 Magnet(2mmx2mmx3mm) $60
2bearing (koyo brand) $6
Machining cost $80
TOTAL more less $363
Leave a comment: