Bedini SG Coils Now Available!

[Ed_Morbus]

Thank you Tom C

[axxelxavier]

George,

Here are the specs for my coil:
Power winding(s) - 130' (32.624m) AWG#20. Measured 0.80mm with digital calipers. 1.322 Ohms measured with milli-ohm meter.
Trigger winding - 130' (32.624m) AWG#24. Measured 0.50mm with digital calipers. 3.430 Ohms measured with milli-ohm meter.

Measurements taken at ambient temperature of 15.2C/59.2F

John K.

John,
Thank you for sharing this.
I think, thought, there is a mistake, 130' are 39,624 m, no 32,624.
Anyway, here is a link to a very good wire calculator: The CircuitCalculator.com Blog » Wire Parameter Calculator
Values of the wires are core only, so, depending on numbers of the protection coatings, the wire is actually a little bit thicker.
Best regards,
Teodor

[John_Koorn]

John,
Thank you for sharing this.
I think, thought, there is a mistake, 130' are 39,624 m, no 32,624.
Anyway, here is a link to a very good wire calculator: The CircuitCalculator.com Blog » Wire Parameter Calculator
Values of the wires are core only, so, depending on numbers of the protection coatings, the wire is actually a little bit thicker.
Best regards,
Teodor

Teodor, thanks for the correction. I went back and corrected the post.

John K.

[D Rhodes]

Love the new look website at TeslagenX - Your source for Radiant Energy Chargers, Experimenter kits, PCBs, Books, Videos & References Great improvement!

[John_Koorn]

Thanks Dennis! Erik has been putting in a lot of hours to get the new site up and running.

The new 8 SG and 4 SG kits are up there now. All of the EFTV videos, Bearden and Bedini books, links to Aaron and Peter's videos and heaps more.

We just have to put up the pricing for the small and large comparators, but email us at service@teslagenx.com if you want any info.

We hope everyone will like it. Please give us your feedback!

John K.

[Howard Wetsman]

I love the coils I got from TeslagenX. I was dreading the winding. thanks guys.
h

[Tom C]

Thanks Howard!

Tom C