Bedini RPX Sideband Generator

* NEW * BEDINI RPX BOOK & DVD SET: BEDINI RPX


2019 ESTC ALL SEATS SOLD OUT!
PRE-REGISTER FOR THE
2020 ENERGY CONFERENCE

Monero XMR

Page 3 of 3 FirstFirst 123
Results 21 to 25 of 25

Thread: Bedini self running method

  1. #21

    Fw pcb

    These PCB's are my version of JB's Ferris Wheel B/C circuit.

    Each PCB is a 1/2 bridge with 5 pairs of pnp/npn MJL transistors

    2 PCB's mounted back to back make a Full Bridge circuit, that can drive a very large Window Motor, or a large Zero Force Motor

    The spacers shown on the PCB's are too long, but allow you to see how it works.

    If the short spacers are used, than the transistors on both PCB's can be laid over and mounted to 1 Heat Sink, 1 on each side of the PCB's
    Attached Images Attached Images

  2. #22
    What is the price on those RS? And how many do you have? I may be interested in two.

  3. #23
    Bradley,
    in bound PM.....
    Last edited by RS_; 10-04-2019 at 07:13 PM.

  4. #24
    After getting reaquainted with the behavior of the B/C half cct, I can easily tell that one does not send energy to the primary batt and the caps for dumping at the same time.
    This is the answer to my first question (above to Aaron)
    bro d

  5. #25
    Hi, still at it.
    Got 3, .1F caps and running with an ssg coil with 3 strands of 22awg for pwr.
    Very poor performance.
    Will try 3 to 8 strands of #18 with matched trannys.
    Garden tractor batts not reliable.
    Working on setup with 4 golf cart large bank and 2 new 100aH batts for the small ones.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •