Bedini RPX Sideband Generator

* NEW * BEDINI RPX BOOK & DVD SET: BEDINI RPX


2019 ESTC ALL SEATS SOLD OUT!
PRE-REGISTER FOR THE
2020 ENERGY CONFERENCE

Monero XMR

Results 1 to 4 of 4

Thread: * NEW RELEASE * The Electrical Properties of Interfacial Water by Kurt Kung, PhD

  1. #1
    Networking Architect Aaron Murakami's Avatar
    Join Date
    Jul 2012
    Location
    Spokane, Washington
    Posts
    1,423
    Blog Entries
    1

    Thumbs up * NEW RELEASE * The Electrical Properties of Interfacial Water by Kurt Kung, PhD

    * NEW RELEASE * The Electrical Properties of Interfacial Water and the Possible Tools to Measure the Subtle Water Characteristics in Vitro by Kurt Kung, Ph.D.



    At the 2018 Energy Science & Technology Conference, Dr. Gerald Pollack who is a professor at the University of Washington presented on the 4th Phase of Water. This is considered to be some of the most authoritative and advanced science in the world of subtle energy research dealing with water.

    Dr. Kurt Kung attended the University of Washington and worked closely with Dr. Pollack who was his adviser at the time and currently, they are partners in ongoing water research and technologies. So if you are looking for more authoritative information on methods to measure subtle energy changes in water, this is the presentation for you.



    ENERGY HARVESTING FROM WATER

    Dr. Kung starts with an overview of some of his work with EZ water, which is the 4th Phase of Water known as "Exclusion Zone" water, which you would be familiar with if you studied Dr. Pollack's work. This is what Dr. Kung is referring to when he is discussing the properties of Interfacial Water and its net negative charge.

    The charge separation that happens when this EZ water is produced is very important because there are two very different types of water that are in close proximity to each other and they do not mix. Therefore, there is a high and low potential or dipole that is formed directly in the water.

    What that means is that you can literally create a battery using one source of water that is simply in contact with a hydrophilic surface, which in turn creates the EZ water separation - if you have two potential differences in that water, then you have a battery. That in fact is what Dr. Kung did - by stringing a bunch of those water cells in series, he was able to light an LED to prove the point. It is a ways off before this is something that can produce large amounts of power, but it is in its infancy and is a profound discovery.

    The Electrical Properties of Interfacial Water and the Possible Tools to Measure the Subtle Water Characteristics in Vitro
    Aaron Murakami





    You never change things by fighting the existing reality. To change something, build a new model that makes the existing model obsolete.” ― Richard Buckminster Fuller

  2. #2
    Senior Member Faraday88's Avatar
    Join Date
    Sep 2012
    Location
    Bangaluru, Karnataka, India
    Posts
    1,527
    Quote Originally Posted by Aaron Murakami View Post
    * NEW RELEASE * The Electrical Properties of Interfacial Water and the Possible Tools to Measure the Subtle Water Characteristics in Vitro by Kurt Kung, Ph.D.



    At the 2018 Energy Science & Technology Conference, Dr. Gerald Pollack who is a professor at the University of Washington presented on the 4th Phase of Water. This is considered to be some of the most authoritative and advanced science in the world of subtle energy research dealing with water.

    Dr. Kurt Kung attended the University of Washington and worked closely with Dr. Pollack who was his adviser at the time and currently, they are partners in ongoing water research and technologies. So if you are looking for more authoritative information on methods to measure subtle energy changes in water, this is the presentation for you.



    ENERGY HARVESTING FROM WATER

    Dr. Kung starts with an overview of some of his work with EZ water, which is the 4th Phase of Water known as "Exclusion Zone" water, which you would be familiar with if you studied Dr. Pollack's work. This is what Dr. Kung is referring to when he is discussing the properties of Interfacial Water and its net negative charge.

    The charge separation that happens when this EZ water is produced is very important because there are two very different types of water that are in close proximity to each other and they do not mix. Therefore, there is a high and low potential or dipole that is formed directly in the water.

    What that means is that you can literally create a battery using one source of water that is simply in contact with a hydrophilic surface, which in turn creates the EZ water separation - if you have two potential differences in that water, then you have a battery. That in fact is what Dr. Kung did - by stringing a bunch of those water cells in series, he was able to light an LED to prove the point. It is a ways off before this is something that can produce large amounts of power, but it is in its infancy and is a profound discovery.

    The Electrical Properties of Interfacial Water and the Possible Tools to Measure the Subtle Water Characteristics in Vitro
    Hi Aaron,
    Is this not just a manifestation of the elecyrolytic contact e.m.f develpoed between disimilar interfaces (EZ), which is same as what happens in Galvanic/Voltic cell.
    The impedance of Pure water as a single cell seems slim as its very high comapred to acidulated/ alkalined water. (raised conductivity)
    Rgds,
    Faraday88.
    ‘Mass is the Spatial density of Matter (Particle) and the Temporal Intensity of Space (Field)’.

  3. #3
    Networking Architect Aaron Murakami's Avatar
    Join Date
    Jul 2012
    Location
    Spokane, Washington
    Posts
    1,423
    Blog Entries
    1
    Quote Originally Posted by Faraday88 View Post
    Hi Aaron,
    Is this not just a manifestation of the elecyrolytic contact e.m.f develpoed between disimilar interfaces (EZ), which is same as what happens in Galvanic/Voltic cell.
    The impedance of Pure water as a single cell seems slim as its very high comapred to acidulated/ alkalined water. (raised conductivity)
    Rgds,
    Faraday88.
    What do you mean by electrolytic contact? There is no electrolyte in the water, just the negatively charged EZ water and positively charged excluded water.
    Aaron Murakami





    You never change things by fighting the existing reality. To change something, build a new model that makes the existing model obsolete.” ― Richard Buckminster Fuller

  4. #4
    Senior Member Faraday88's Avatar
    Join Date
    Sep 2012
    Location
    Bangaluru, Karnataka, India
    Posts
    1,527
    Quote Originally Posted by Aaron Murakami View Post
    What do you mean by electrolytic contact? There is no electrolyte in the water, just the negatively charged EZ water and positively charged excluded water.
    Agreed, but the impedance still is high with pure water to draw any serious power out of the 'battery'
    I feel there has to be some thing in conjunction to make it deliver Power to an external load.
    Rgds,
    Faraday88.
    ‘Mass is the Spatial density of Matter (Particle) and the Temporal Intensity of Space (Field)’.

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •