Bedini RPX Sideband Generator

* NEW * BEDINI RPX BOOK & DVD SET: BEDINI RPX


2019 ESTC ALL SEATS SOLD OUT!
PRE-REGISTER FOR THE
2020 ENERGY CONFERENCE

Monero XMR

Search:

Type: Posts; User: Yoe777

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. Thread: Wtb - s160a24

    by Yoe777
    Replies
    2
    Views
    2,121

    Wtb - s160a24

    Want to buy a S160A24 unit from someone or trade a S80A12 with some cash for one.

    PM me.

    Thx
  2. Replies
    89
    Views
    12,552

    SG8 Pot location

    I understand for to tune the SG8 that you need to replace the 470 ohm base resistors with 100 ohm base resistors. On what area would I place the pot on the SG8? Here is a pic of mine:

    3713
  3. Replies
    11
    Views
    4,548

    Additional pics.

    Additional pics.
  4. Replies
    11
    Views
    4,548

    3" spacing, the magnets are the recommended ones...

    3" spacing, the magnets are the recommended ones in the SG Handbook, 1"x2.5" Ceramic #8.
  5. Replies
    11
    Views
    4,548

    Got it. I only had the SG running 3 days. Did...

    Got it. I only had the SG running 3 days. Did I just get a bad transistor? Also where would I place a fuse in the board to prevent a similar issue again?
  6. Replies
    11
    Views
    4,548

    Yes I know, that's not what I asked though. I...

    Yes I know, that's not what I asked though. I have to say that my success using these forums has been minimal and I am starting to loose faith in it.

    I love these areas that have been...
  7. Replies
    7
    Views
    2,636

    I did build one. I can't spend thousands on R&D...

    I did build one. I can't spend thousands on R&D to find out what sizes are best. I thought that I could work off of people's experience. Is that not one of the main reasons of this forum?
  8. Replies
    7
    Views
    2,636

    What are the pros vs cons of various sizes?

    What are the pros vs cons of various sizes?
  9. Replies
    11
    Views
    4,548

    So assuming there was no short, the core of the...

    So assuming there was no short, the core of the coil naturally heated up until the glue & plastic melted?
  10. Replies
    7
    Views
    2,636

    What type of plexiglass? What size and how many...

    What type of plexiglass? What size and how many magnets?
  11. Thread: Cop

    by Yoe777
    Replies
    2
    Views
    1,541

    7 Transistors, 18 magnets, coil 4.5".

    7 Transistors, 18 magnets, coil 4.5".
  12. Replies
    7
    Views
    2,636

    Rotor Wheel Alternates

    What are some better alternatives for a rotor wheel are there then the bike wheel?
  13. Thread: Cop

    by Yoe777
    Replies
    2
    Views
    1,541

    Cop

    What should my target goal be in Amps on reading on my Primary and Charge side?
  14. Replies
    11
    Views
    4,548

    Catastrophic failure of SG.

    I came home today to find all of my Transistors blown. Upon investigation I looked at my coil and the core had melted out then grounded on my magnet.

    I was approaching 15v on my battery. Does...
  15. Replies
    7
    Views
    32,510

    Of course you need to put them in parallel for...

    Of course you need to put them in parallel for 12v. From people that I have been talking to I have been led to believe that putting 8 pairs in parallel is pushing it. My solar array is aprx 1500...
  16. Replies
    7
    Views
    32,510

    I have read it and been a follower of Bedini and...

    I have read it and been a follower of Bedini and Peters research for a while now.

    What do you mean "You can't go past" The T105's. How many could you put in parrell?
  17. Replies
    7
    Views
    32,510

    80A 12v vs 24v Solar Tracker V for Off Grid

    I have a Solar Tracker V 80A12V. I am now thinking perhaps I should have went with a 24volt system. I am not sure why they offer 80A/160A in 12 volt versions. I want it to be a scalable system...
  18. Replies
    49
    Views
    20,405

    Looks like you were constructing part of my...

    Looks like you were constructing part of my answer soon as I was writing it.

    :)
  19. Replies
    49
    Views
    20,405

    What shaft / bearings did you use? Did the new...

    What shaft / bearings did you use? Did the new rod just fit in after the old one?

    Thanks for the pics!
  20. Replies
    0
    Views
    1,404

    JB / Ralph 6 Pole Monopole

    Can someone post me some information about the JB / Ralph 6 Pole Monopole? I came across a few vids on YouTube and a few things in the forum but that is about it.

    Can I purchase schematics...
  21. Replies
    3
    Views
    3,164

    lol! Your response sounds familiar to previous...

    lol! Your response sounds familiar to previous situations I've been in but that does not mean they will not deliver. He is a engineer... and i'm sure he had to learn how to run a business among the...
  22. Replies
    3
    Views
    3,164

    Anyone Familiar with the Magnacoaster?

    Anyone Familiar with the Magnacoaster?

    Did he independently discover the same principals as Bedini?


    http://www.magnacoaster.com

    Magnacoastermotors - YouTube
  23. Replies
    38
    Views
    29,455

    Sticky: I'm talking about the way the batteries are each...

    I'm talking about the way the batteries are each connected to a terminal block as illustrated in the picture. There are benefits in doing this with a conventional solar setup. What I was asking are...
  24. Replies
    38
    Views
    29,455

    Sticky: 2148 This was the way I was going to setup my...

    2148

    This was the way I was going to setup my battery bank. With this Tesla Technology would it make the benefits of doing this obsolete?
  25. Replies
    38
    Views
    29,455

    Sticky: Tom C ... your at full PM storage capacity. What...

    Tom C ... your at full PM storage capacity. What inverter would you recommend in a grid tied situation? And what would you recommend for a non grid tied situation?
Results 1 to 25 of 27
Page 1 of 2 1 2