Bedini RPX Sideband Generator

* NEW * BEDINI RPX BOOK & DVD SET: BEDINI RPX


2019 ESTC ALL SEATS SOLD OUT!
PRE-REGISTER FOR THE
2020 ENERGY CONFERENCE

Monero XMR

Search:

Type: Posts; User: mpgmike

Search: Search took 0.00 seconds.

  1. Replies
    1,223
    Views
    367,523

    The Pulstars with the Aquapulser active didn't...

    The Pulstars with the Aquapulser active didn't put out anything near a plasma spark. It acted like a CDI level spark that never quenched; it just buzzed. Pulstars are classed as Resistor spark...
  2. Replies
    1,223
    Views
    367,523

    Thank you very much! Attached is a scope shot...

    Thank you very much!

    Attached is a scope shot of the "kill wire" in the top red trace with a vacuum signal on the bottom yellow trace. This is with no load. I used a 5 HP Honda engine from a...
  3. Replies
    1,223
    Views
    367,523

    The Hyundai is gone. I don't have EMF issues...

    The Hyundai is gone. I don't have EMF issues with the Jeep, just too short plug life. I intend to build/assemble a weaker system than the Aquapulser for the Jeep. I believe (after reading the 122...
  4. Replies
    3
    Views
    128

    I have been intrigued by this since I read about...

    I have been intrigued by this since I read about it years ago. I don't have a garden, nor do I need to seed fish in my lake. But I've been trying to share it with anybody that could benefit, hoping...
  5. Replies
    3
    Views
    128

    Capacitive Incubation

    In the 1991 Guido Ebner and Heinz Schürch were granted US Patent #5,048,458; "Method of Breeding Fish". There was an equivalent New Zealand Patent #NZ 229689 A. The process is essentially placing...
  6. Thread: Why?

    by mpgmike
    Replies
    9
    Views
    4,413

    As for what I want, on another forum my signature...

    As for what I want, on another forum my signature reads, "I don't need the world to know my name, I just want my great grandchildren to proudly remember me." Of course, no matter how bad off we are...
  7. Replies
    1,223
    Views
    367,523

    I wish I had pictures of the simple version, but...

    I wish I had pictures of the simple version, but here are a few of the timing controller with the hand-held programmer. First pic is of the controller. Second pic is of the controller & coil...
  8. Replies
    1,223
    Views
    367,523

    Also, I design electronic controls for a living. ...

    Also, I design electronic controls for a living. I've seen a few requests for a simple electronic controller for single cylinder gasoline engines that would allow elimination of waste spark &...
  9. Replies
    1,223
    Views
    367,523

    Electricity went out early Monday afternoon (NE...

    Electricity went out early Monday afternoon (NE US storm) and stayed out for 75 hours. Since I couldn't work, I caught up on some reading. Started with Post #1 and read through to #1212. I learned...
  10. Replies
    7
    Views
    3,328

    7337 I found the real challenge was in getting...

    7337
    I found the real challenge was in getting the 3 batteries/capacitors to couple properly using only MOSFETS (could use IGBTs or transistors as well). Whether time or voltage based, the...
  11. Timing is Critical After too many, “Ooh, if...

    Timing is Critical

    After too many, “Ooh, if only it were a couple months later…” replies, we have decided to reschedule the premier Alternative Energy International Expo. Originally slated for...
  12. As a side note, we have made sure there is plenty...

    As a side note, we have made sure there is plenty of interaction time. Back in the 90's I was involved with Paul Pantone and his GEET Fuel Processor. I contributed much to the understanding and...
  13. Alternative Energy International Expo, Florida

    Aaron has graciously given permission to announce the upcoming Alternative Energy International Expo in Clearwater, Florida this March 23 and 24th. The venue is a 5000 square foot building with...
  14. Replies
    7
    Views
    3,328

    It's working. I tested an LED with a 470 Ohm...

    It's working. I tested an LED with a 470 Ohm resistor. I was getting about 2.5X the work from it (only used 40% of the amps to drive the LED). Stepping it up for heavier loads. Will be testing...
  15. Replies
    7
    Views
    3,328

    Comments? Questions? Observations? Sarcastic...

    Comments? Questions? Observations? Sarcastic remarks?
  16. Replies
    7
    Views
    3,328

    Solid State Bedini Switching Circuit

    Background
    I spent some time converting John Bedini’s Battery Switching (BBS) concept from toggle switches or relays to a fully MOSFET controlled circuit. I found the key lies in the use of diodes....
  17. Thread: Why?

    by mpgmike
    Replies
    9
    Views
    4,413

    For one, I like to say, "I'd have to get 100 MPG...

    For one, I like to say, "I'd have to get 100 MPG for 100 years to get an ROI on what I spent learning how to get 100 MPG." I started out as a "car guy" who had to learn electronics, out of...
  18. Thread: Why?

    by mpgmike
    Replies
    9
    Views
    4,413

    Why?

    There are a myriad of technologies that have been developed over the ages. This forum showcases the trials & errors, and successes of participating experimenters. On one hand, if everyone held...
  19. Thread: Rife Machine

    by mpgmike
    Replies
    24
    Views
    18,608

    One of the challenges of building a Rife type...

    One of the challenges of building a Rife type frequency generation device is producing fairly exact frequencies over an incredible range. The PIC Microcontroller family offers a Special Function...
  20. Replies
    6
    Views
    11,495

    Solid state would be even better.

    Solid state would be even better.
Results 1 to 20 of 20