Bedini RPX Sideband Generator

* NEW * BEDINI RPX BOOK & DVD SET: BEDINI RPX


2019 ESTC ALL SEATS SOLD OUT!
PRE-REGISTER FOR THE
2020 ENERGY CONFERENCE

Monero XMR

Search:

Type: Posts; User: jd_zinke@hotmail.com

Search: Search took 0.00 seconds.

  1. Replies
    0
    Views
    924

    Free Plasma

    Anyone doing anything with the recently released Keshe Free Plasma and GaNS info/??
  2. Replies
    17
    Views
    11,201

    On your internal coil, consider pairing up two...

    On your internal coil, consider pairing up two leads and treat the two as a 2 conductor Tesla Bifilar coil, joining one of the ends of on one end with one wire end on the opposite end of the coil. ...
  3. You will have to omit step 2-1, if you apply the...

    You will have to omit step 2-1, if you apply the generator modification (generator mode). If you complete the assembly per the instruction book that comes with the Teslagenx 8 board and later on add...
  4. To get some usable voltage, I had to put the gen...

    To get some usable voltage, I had to put the gen coil less than 1/8 inch from the wheel. I'm hoping that the coil-shorting technique will produce sufficient voltage that I can back the coil away to...
  5. Common Ground Switch(Generator Mode) & Adding a Generator Coil - Observations

    A. After some guidance and clarifications from Teslagenx, I wired in a SPDT switch with the 8 transistor board and Charge battery connections. This results in a switchable charging mode. First...
  6. Replies
    17
    Views
    11,201

    Update

    James,

    I applied your recommendations and got the generator coils connected in series, ending with one wire at the top and one at the bottom. Thanks for the advice. It reduce the confusion of...
  7. Replies
    17
    Views
    11,201

    GREAT Info!!

    Thank you for responding with so much detail. Yes, I have the TeslaGenx board and their 8 & 1 power coil. Both are quality products. I understand almost all of your comments. I have the generator...
  8. Replies
    17
    Views
    11,201

    Generator Coil

    Thanks, James. I'm surmising that you are using the 8 tranny board and 8/20 gauge power & 1/23 gauge trigger strands, twisted 130 ft. coil.......

    1.) Are you using the 18 ceramic magnet...
  9. Replies
    17
    Views
    11,201

    Advanced Model Questions

    Thanks for your ideas and suggestions, Aaron. I'm changing some of my original design by placing an Amp meter on the low-drag generator output, rather than the Charging output. After tuning the...
  10. CAPS Experiments

    THANKS TO YOU, DIESELSHIP!
    I watched the clip you referenced and became even more motivated! I built the TeslagenX 8 tranny board as the base to expand my knowledge. It's a great, high-quality...
  11. Have you or Dieselship tried a Cap-battery on the...

    Have you or Dieselship tried a Cap-battery on the front end?? They appear to have both a small internal battery and 6 super caps. I'm thinking out loud here.... But, the caps would create an...
  12. Replies
    1
    Views
    2,510

    Maximizing Radiant Energy

    I want to maximize the radiant energy output reaching the Charge battery, so I'm not adding a capacitor discharge or Comparator to this build. However, I want to combine some Intermediate features...
  13. Sticky: The 8 channel TeslaGenX kit supplied only one...

    The 8 channel TeslaGenX kit supplied only one type of diode. Is there a reason you list 2 types here??
  14. Replies
    17
    Views
    11,201

    Misc. Advanced Bedini Questions

    I would appreciate your suggestions/experience on the following questions:

    1.) I do not have the JB Comparator at this time. With that in mind, where, on the TeslagenX 8 channel board, do the...
Results 1 to 14 of 14