Bedini RPX Sideband Generator

* NEW * BEDINI RPX BOOK & DVD SET: BEDINI RPX


2019 ESTC ALL SEATS SOLD OUT!
PRE-REGISTER FOR THE
2020 ENERGY CONFERENCE

Monero XMR

Search:

Type: Posts; User: daucupace

Search: Search took 0.00 seconds.

  1. Replies
    13
    Views
    1,859

    Hi Gary, Thank you for the reply. I rechecked...

    Hi Gary,

    Thank you for the reply. I rechecked and did reheat some solder joints but I think they were already soldered good in the first place...,some of the solder can not be seen because it...
  2. Replies
    13
    Views
    1,859

    Hi Joster, I get 1.4 - 1.5 ohm for each power...

    Hi Joster,

    I get 1.4 - 1.5 ohm for each power winding and 3 ohm for the trigger...seems good to me..
  3. Replies
    13
    Views
    1,859

    Hi Joster, Thanks for the quick reply. I...

    Hi Joster,

    Thanks for the quick reply.
    I removed the 10w and the 100ohm 2watt resistor and only the 4w potentiometer and the 100ohm 1 watt resistor going to each transistor base remained,...
  4. Replies
    13
    Views
    1,859

    Hello everyone, I put the new 4watt...

    Hello everyone,

    I put the new 4watt potentiometer with the 100 ohm 2 watt resistor as shown in below picture, unfortunately it's still the same issue, low current draw...
    7497

    What could I...
  5. Replies
    13
    Views
    1,859

    Hi Joster, Thank you for the suggestions. I...

    Hi Joster,

    Thank you for the suggestions. I bought this 1k 4w potentiometer:
    https://www.tme.eu/ro/details/pot4w-1k/potentiom-axiale-cu-o-sing-tura-cablu/ab-elektronik/3104605994/
    since they...
  6. Replies
    13
    Views
    1,859

    Hello RS_, Thank you for the input. I did...

    Hello RS_,

    Thank you for the input. I did understood that it's not a good idea to run the SSG without the output battery connected. I didn't ran it for very long periods of time... as I did find...
  7. Replies
    13
    Views
    1,859

    additional pictures with coil and wire...

    additional pictures with coil and wire descriptions.7488
    7489749074917492
  8. Replies
    13
    Views
    1,859

    Help setting up Bedini SG properly.

    Hello to everybody,

    I would need some adivse/help with my Bedini SG build.
    Specs:
    28" aluminium bicycle wheel
    18 - ceramic c8 magnets from teslagenx on wheel
    7x20AWG+1x23AWG 130' --...
  9. Hi Deuis, Thank you very much for the...

    Hi Deuis,

    Thank you very much for the reply/information.
    I will try to stick the magnets to the rim with double sided tape (since it won't hold without it since the rim is aluminium not steel)...
  10. 3D print files for magnet holder on 28" rim

    Hello,
    I am trying to build the Bedini SG with a 28 inch bicycle rim which I have available.
    I have the ceramic C8 magnets (which are 1 7/8" (47.6mm) long by 7/8" (22.2mm) wide and 3/8" (9.5mm))...
Results 1 to 10 of 11