Bedini RPX Sideband Generator

* NEW * BEDINI RPX BOOK & DVD SET: BEDINI RPX


2019 ESTC ALL SEATS SOLD OUT!
PRE-REGISTER FOR THE
2020 ENERGY CONFERENCE

Monero XMR

Search:

Type: Posts; User: Nityesh Schnaderbeck

Page 1 of 8 1 2 3 4

Search: Search took 0.00 seconds; generated 1 minute(s) ago.

  1. Great Job, I am going to try your Circuit, Thanks...

    Great Job, I am going to try your Circuit, Thanks

    I had some discovery's, with my "Tri-symetrical 3 battery switch" experiments, with reversed transistors and reversed LEDs.
    I will have to do...
  2. Tell Her very nice Work:fingerdance::clap:

    Tell Her very nice Work:fingerdance::clap:
  3. Replies
    113
    Views
    34,209

    Thankyou Aaron Murakami and Dave Wing, for the...

    Thankyou Aaron Murakami and Dave Wing, for the info

    I can see from John Bedini's, timing diagram, that he would have had either 2 sets( or more) of timing sensors for the short pulses and the long...
  4. Hello James You are not a nutter, you are a...

    Hello James You are not a nutter, you are a genious, with a more developed sense of intuition then the average person. Be good to yourself.

    It is a real skill to explain this stuff, and if you...
  5. Hello everyone, Here is something about John...

    Hello everyone,

    Here is something about John Bedini's Ferris wheel and Patricks motor :cool:5012:cool:

    In The Bedini SG - The Complete Advanced Handbook(sgadv.pdf), Page 87, it shows the...
  6. Thankyou BobZilla

    Thankyou BobZilla
  7. Hello BobZilla What is the chip on your Arduino,...

    Hello BobZilla
    What is the chip on your Arduino, Have you ever programed your Arduino to decode the grey code from a rotary encoder.
    Does your Arduino have an I2C (I squared C Bus) interface.
    I...
  8. John_Koorn Thankyou for your reply Using a 1:1...

    John_Koorn Thankyou for your reply

    Using a 1:1 pulse transformer, will give you a more accurate voltage reading than optos, because voltage in equals voltage out (minus losses).
    ...
  9. Are you going to run this in generator mode, or...

    Are you going to run this in generator mode, or standard ssg mode.

    In generator mode the voltage to the capture cap triggers the comparator. If you are using the standard ssg mode, then you can...
  10. Here are some solutions to measure an isolated...

    Here are some solutions to measure an isolated voltage,

    I could use this circuit.

    http://www.energyscienceforum.com/attachment.php?attachmentid=5061&d=1451171168

    But I think it would be best...
  11. John_Koorn Thank you for your reply Yes you...

    John_Koorn Thank you for your reply

    Yes you are right about, the PIC chip requires a common ground in order to use the ADC inputs to take measurements.

    To take these measurements, all 3 battery...
  12. John_Koorn Thankyou for your comments, The PIC...

    John_Koorn Thankyou for your comments, The PIC micro-controllers are wonderful chips.

    I have an idea that I think might just work. It would be very convenient to have 3 voltage displays,...
  13. I now have the PIC16F690 micro controller driving...

    I now have the PIC16F690 micro controller driving the Tri-Symmetrical 3 Battery Tesla Switch with variable frequency adjust and real time dead zones (dead zones don't change with frequency).
    ...
  14. I remember you talking about frequencies a year...

    I remember you talking about frequencies a year ago, in relation to the omibus 80 strand solid state oscillator. That 80 strand oscillator, is still the best machine, with the highest COP I have ever...
  15. Replies
    74
    Views
    26,893

    I am using 2 back to back yellow 5mm LEDs as the...

    I am using 2 back to back yellow 5mm LEDs as the load. Here is the picture of my setup. The battery is 2 LI-Ion cells, connected in series and reads 7.36V battery voltage.
    ...
  16. Replies
    74
    Views
    26,893

    I have have this circuit up and running. ...

    I have have this circuit up and running.

    http://www.energyscienceforum.com/attachment.php?attachmentid=5041&d=1450097009

    So far the battery voltage has remained frozen, (12hours later), With...
  17. Hello jamesgray3rd Thankyou for you very...

    Hello jamesgray3rd Thankyou for you very interesting comments.


    5047

    I think that With John Bedini's zero force motor, the capacitors are inside the coil, sure. I think the schematic was...
  18. More about the coil capacitor construction. I...

    More about the coil capacitor construction.

    I have experimented with Tesla Pancake coils, I have transmitted and received power, with 1 wire connection. I have found that you can also stack...
  19. Replies
    74
    Views
    26,893

    Remember that you changed some components from...

    Remember that you changed some components from the original Ron Cole Bipolar Switch.



    With the 4 battery Bedini Tesla Switch it was suggested to power the SG3524N circuit with an adjustable...
  20. Replies
    74
    Views
    26,893

    This circuit is to find out if "Reversed...

    This circuit is to find out if "Reversed Electricity" appears in the Ron Cole Switch

    The test is to see if Red LED1 & Red LED2 flash.
    ...
  21. Replies
    74
    Views
    26,893

    John_Korn Have you tried to completely isolate...

    John_Korn Have you tried to completely isolate the 555 timer driver circuit, from the battery switching circuit, and run the 555 timer driver circuit on it's own power supply, with your Ron Cole...
  22. Replies
    74
    Views
    26,893

    Here is a simplified Ron Cole Switch that would...

    Here is a simplified Ron Cole Switch that would be good for experimenting with small batteries like AA Ni-cads. The original Ron Cole Switch, would be able to switch more current than this one.
    ...
  23. Replies
    74
    Views
    26,893

    Thankyou BobZilla, Nice work, with an aurduino,...

    Thankyou BobZilla, Nice work, with an aurduino, is it easy to program?.

    Most
    Kindest
    Regards
    Nityesh Schnaderbeck
  24. Replies
    74
    Views
    26,893

    So that's why the chargers work so well, they use...

    So that's why the chargers work so well, they use precision timing from a Xtal, That explains it. The first Bedini pulse chargers, are almost the same as the Ron Cole Bipolar Switch with the Cap dump...
  25. Xtal Locked Timing Circuits for Tesla Switch's.

    This thread is Dedicated to the research and development of a Crystal locked timing circuit. To control, The Tri-Symmetrical 3 Battery Tesla Switch, 4 Battery Bedini Tesla Switch or the Ron Cole...
Results 1 to 25 of 186
Page 1 of 8 1 2 3 4