Bedini RPX Sideband Generator

* NEW * BEDINI RPX BOOK & DVD SET: BEDINI RPX


2019 ESTC ALL SEATS SOLD OUT!
PRE-REGISTER FOR THE
2020 ENERGY CONFERENCE

Monero XMR

Search:

Type: Posts; User: heysoundude

Page 1 of 4 1 2 3 4

Search: Search took 0.00 seconds.

  1. Replies
    1,152
    Views
    332,180

    it appears to me (thank you for the link!) that...

    it appears to me (thank you for the link!) that mobilizing boundary later air at all transitions in an intake improves air-fuel charge homogenization.
    this is the same principle as the divots on...
  2. Replies
    1,152
    Views
    332,180

    power lynz? I googled that but didn't get a...

    power lynz? I googled that but didn't get a relevant result.
    would you be so kind as to elaborate?

    I found this video of the process:
    https://www.youtube.com/watch?v=_vzcoTCiJto

    Gadgetman...
  3. Replies
    1,152
    Views
    332,180

    That does seem excessive. Are there Iridium...

    That does seem excessive. Are there Iridium equivalents you can use?
    also, remember the M in MSD stands for Multi; it's possible that the multiple discharges are prematurely wearing the plugs, I...
  4. Replies
    1,152
    Views
    332,180

    This may be of interest for your ultrasonic...

    This may be of interest for your ultrasonic setup: https://eagle-research.com/product/float-switch-circuit-board/
    I'm willing to wager that it could be used to monitor water level and remind you to...
  5. Replies
    1,152
    Views
    332,180

    That is a very good idea, and you're lucky to...

    That is a very good idea, and you're lucky to have such kind friends
  6. Replies
    1,152
    Views
    332,180

    Me either - what I wrote was meant to discourage...

    Me either - what I wrote was meant to discourage that. Change your coil instead. As for wires...well, you'll have to experiment with that yourself.
  7. Replies
    1,152
    Views
    332,180

    My Torquemasters have resistors, because my...

    My Torquemasters have resistors, because my research has indicated that my ignition coils seem to function best with somewhat of a resistive load on them. The factory specifies ignition cables with...
  8. Replies
    1,152
    Views
    332,180

    That's quite the blog/adventure! Your spark plug...

    That's quite the blog/adventure! Your spark plug research is particularly impressive. I have Torquemaster resistor plugs in my vehicle, and they have had a positive effect on how the engine runs...
  9. Replies
    1,152
    Views
    332,180

    what happened to the exchanger coil in the "high...

    what happened to the exchanger coil in the "high power" portion of the video?
    (the coils work better when the flows oppose each other - it looked like you had yours reversed from this)
  10. Replies
    1,152
    Views
    332,180

    everything works fine except when you connect the...

    everything works fine except when you connect the MSD box...MSD suggests the Pertronix coil has too low of an impedence on the primary:
    sounds to me like you need to hack the MSD to swap out the...
  11. Replies
    1,152
    Views
    332,180

    so, how'd it go?

    so, how'd it go?
  12. Replies
    1,152
    Views
    332,180

    You might give up too quickly:...

    You might give up too quickly:
    https://eagle-research.com/product/carburetor-enhancer-manual-third-edition/
    I'm certain it's quite possible with stock/factory equipment and certain add-ons to...
  13. Replies
    1,152
    Views
    332,180

    definitely looks like it's blowing the ignition...

    definitely looks like it's blowing the ignition plasma energy well into the cylinder compared to "standard" ignition, but what I was looking for is the proof/evidence that it leads to longer plug...
  14. Replies
    1,152
    Views
    332,180

    How is the geometry wrong? and where can I find...

    How is the geometry wrong?
    and where can I find proof about the firestorm?
  15. Replies
    1,152
    Views
    332,180

    If Torquemaster are willing to make tungsten...

    If Torquemaster are willing to make tungsten plugs, it might be worthwhile asking if they'd be willing to make Beryllium Copper plugs. Surely they would buy the supplies if there was a demand for...
  16. Replies
    1,152
    Views
    332,180

    why not see how far you can go before misfire by...

    why not see how far you can go before misfire by opening plugs +10% of stock until it does misfire? (.038-.041-.044...) or power/mileage begin to drop?
    if your car has a carb/distributor, you could...
  17. Trust but verify:...

    Trust but verify:
    http://free-energy-info.com/SChapt10.html
    use the last circuit, stacked, with the upgraded diodes...and grounding is SUPER important.
  18. Replies
    1,152
    Views
    332,180

    This is a wonderful exchange showing what can be...

    This is a wonderful exchange showing what can be accomplished with a number of combustion efficiency additions to a ICE-equipped vehicle operating in concert;
    while this was focused on plasma...
  19. Replies
    1,152
    Views
    332,180

    there should be a growing demand for those...or...

    there should be a growing demand for those...or an investor/businessperson willing to invest in green technology should step in to hold limited stock
  20. Replies
    1,152
    Views
    332,180

    Watch your inbox for a delivery. I also have...

    Watch your inbox for a delivery.

    I also have MUCH to learn when it comes to everything, especially electronics/electricity, and that's why I'm trying to keep the convo/experimentation moving...
  21. Replies
    1,152
    Views
    332,180

    @Realtravel please reference the attached diagram...

    @Realtravel please reference the attached diagram
    720 degrees divided by 6 cyl is 120 degree dwell time. put that into the earlier ignition calculator link with a 14.1V voltage (what should be...
  22. Replies
    1,152
    Views
    332,180

    Based on what I'm familiar with GM having done in...

    Based on what I'm familiar with GM having done in that time period, this may (or may not) be of some help to you if your car's ignition is from the global supply chain/parts...
  23. Replies
    1,152
    Views
    332,180

    A ballpark is a pretty big place; I think this is...

    A ballpark is a pretty big place; I think this is more in between horseshoes and hand grenades close ;)how much of the primary discharges to the secondary? who cares, as long as the energy does...
  24. Replies
    1,152
    Views
    332,180

    OOPS! thanks for correcting that, Aaron.No, I've...

    OOPS! thanks for correcting that, Aaron.No, I've not found (stumbled across) one for CDI...but wouldn't the speed you're looking for be "c"? or were you meaning charging TIME? easy enough to...
  25. Replies
    1,152
    Views
    332,180

    has anyone input their coil's etc specs into this...

    has anyone input their coil's etc specs into this calculator?http://bgsoflex.com/igncoil.htmljust in case it might help to fine tune anything...
Results 1 to 25 of 86
Page 1 of 4 1 2 3 4