Search:

Hi Gary,

Thank you for the reply. I rechecked and did reheat some solder joints but I think they were already soldered good in the first place...,some of the solder can not be seen because it...

Hi Joster,

I get 1.4 - 1.5 ohm for each power winding and 3 ohm for the trigger...seems good to me..

Hi Joster,

Thanks for the quick reply.
I removed the 10w and the 100ohm 2watt resistor and only the 4w potentiometer and the 100ohm 1 watt resistor going to each transistor base remained,...

Hello everyone,

I put the new 4watt potentiometer with the 100 ohm 2 watt resistor as shown in below picture, unfortunately it's still the same issue, low current draw...
7497

What could I...

Hi Joster,

Thank you for the suggestions. I bought this 1k 4w potentiometer:
https://www.tme.eu/ro/details/pot4w-1k/potentiom-axiale-cu-o-sing-tura-cablu/ab-elektronik/3104605994/
since they...

Hello RS_,

Thank you for the input. I did understood that it's not a good idea to run the SSG without the output battery connected. I didn't ran it for very long periods of time... as I did find...

additional pictures with coil and wire descriptions.7488
7489749074917492

Hello to everybody,

I would need some adivse/help with my Bedini SG build.
Specs:
28" aluminium bicycle wheel
18 - ceramic c8 magnets from teslagenx on wheel
7x20AWG+1x23AWG 130' --...

Hi Deuis,

Thank you very much for the reply/information.
I will try to stick the magnets to the rim with double sided tape (since it won't hold without it since the rim is aluminium not steel)...

Hello,
I am trying to build the Bedini SG with a 28 inch bicycle rim which I have available.
I have the ceramic C8 magnets (which are 1 7/8" (47.6mm) long by 7/8" (22.2mm) wide and 3/8" (9.5mm))...