Bedini RPX Sideband Generator

* NEW * BEDINI RPX BOOK & DVD SET: BEDINI RPX


2019 ESTC ALL SEATS SOLD OUT!
PRE-REGISTER FOR THE
2020 ENERGY CONFERENCE

Monero XMR

Search:

Type: Posts; User: RS_

Page 1 of 15 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    29
    Views
    5,422

    Joster, A trigger strand on the coils would...

    Joster,

    A trigger strand on the coils would most likely work on the ZFM the same as a Window Motor........
  2. Replies
    29
    Views
    5,422

    Yaro, What kind of Bipolar B/C circuit...

    Yaro,

    What kind of Bipolar B/C circuit arrangement are you going to use to drive this 3 coil ZFM...? this is Very different than a 2 or 4 coil arrangement...
    do you have 3 or 6 magnets on the...
  3. Replies
    24
    Views
    5,539

    Bradley, in bound PM.....

    Bradley,
    in bound PM.....
  4. Replies
    24
    Views
    5,539

    Fw pcb

    These PCB's are my version of JB's Ferris Wheel B/C circuit.

    Each PCB is a 1/2 bridge with 5 pairs of pnp/npn MJL transistors

    2 PCB's mounted back to back make a Full Bridge circuit, that can...
  5. Replies
    24
    Views
    5,539

    Hi Bro D, I have more of the JB Ferris Wheel 5...

    Hi Bro D,

    I have more of the JB Ferris Wheel 5 pnp/npn Transistor B/C circuit PCB's that I Had for sell at the 2019 conference if you would like one to make your 1/2 bridge circuit to drive...
  6. Thread: The Toy Build

    by RS_
    Replies
    44
    Views
    7,420

    well i need to order some new NiZn cells and dig...

    well i need to order some new NiZn cells and dig out that old project box and see if i can make it go OU again, I did it before the shop fire destroyed the first model, but the rebuild was lacking,...
  7. Thread: The Toy Build

    by RS_
    Replies
    44
    Views
    7,420

    How about this...? ...

    How about this...?

    https://www.amazon.com/melasta-Rechargeable-Batteries-2600mWh-Battery/dp/B07QB1GZV2/ref=sr_1_5?keywords=nizn+batteries&qid=1565577691&s=gateway&sr=8-5
  8. Thread: The Toy Build

    by RS_
    Replies
    44
    Views
    7,420

    well for $26.99 for 16 is not a bad deal. It...

    well for $26.99 for 16 is not a bad deal. It will take 24 AA battery's to replace all the Ni-Cd's for this old project. And now that I can automate battery swapping, it will take even...
  9. Thread: The Toy Build

    by RS_
    Replies
    44
    Views
    7,420

    Hi Bob, These NiZn cells are very...

    Hi Bob,

    These NiZn cells are very interesting... I have heard of them, but never seen anyone using them in a Bedini type charger.... Can you expound on there use in Bedini charger applications..?...
  10. Replies
    26
    Views
    6,330

    Yes Mr. Aviso Ismael does the Ring the Ring and...

    Yes Mr. Aviso Ismael does the Ring the Ring and Kone head follows him quite closely over on the EV Gray Forum.... I have not read that forum in quite a while, so I don't know anything more about...
  11. Replies
    11
    Views
    2,779

    If you are having heat issues in your cores, than...

    If you are having heat issues in your cores, than your rods are to big in dia, or they are the wrong material
  12. Replies
    11
    Views
    2,779

    Bradley, Yes green floral wire will work and...

    Bradley,
    Yes green floral wire will work and even the small gauge is useful. In my understanding the more isolated rods in the core the better, creates more magnetic field streams. I contemplated...
  13. Replies
    11
    Views
    2,779

    The problem with those welding rods is that the...

    The problem with those welding rods is that the grey flux is too thick.... if you soak those rods in water until the flux melts, and then sand the rods a little, and soak them again and then let...
  14. Replies
    11
    Views
    2,779

    If you find a equivalent to R60 rods without the...

    If you find a equivalent to R60 rods without the copper coating, after cutting to length, soak them in water for a while, then let them rust (oxidation) for a while, and that will create the...
  15. Replies
    26
    Views
    6,330

    ah yea i remember that School boy sch now.... i...

    ah yea i remember that School boy sch now.... i was doing similar things during that time frame...

    JB told me that when you back pop the primary battery that a ssg circuit or a JB/Cole circuit as...
  16. Replies
    26
    Views
    6,330

    In what case do you feel the Capacitor be...

    In what case do you feel the Capacitor be completely isolated from the SSG during the dump if not in this case?

    I dont understand this question....

    The Commutator will isolate the SSG circuit...
  17. Replies
    26
    Views
    6,330

    1. I do not know anything about Ricks school boy...

    1. I do not know anything about Ricks school boy motor..... What I do know is that if you are not filling a cap during the SSG run time, you are wasting all the energy the genny coils produce...
  18. Replies
    26
    Views
    6,330

    Add a large Cap to the output of the FWBR. Make...

    Add a large Cap to the output of the FWBR. Make it a value that will fill up to 35V or so in between the Split commutator's switching..... Draw a Split Commutator. The Commutator needs to be geared...
  19. Replies
    32
    Views
    6,779

    That will be very interesting if the 2 back to...

    That will be very interesting if the 2 back to back H11D1's will switch correctly with the incoming magnet, and the out going magnet phase....

    if it does work, than you can feed the spike back to...
  20. Replies
    32
    Views
    6,779

    wow, someone really butchered one of my...

    wow, someone really butchered one of my Schematics. i'm not even sure what it's susposta do.....

    edit:

    after studying this. i see that they are trying to get the charging battery to drive the...
  21. Replies
    91
    Views
    27,820

    Yaro, Yes that is True on adjusting the...

    Yaro,

    Yes that is True on adjusting the Pulse width.... and then adjust the position of the timing wheel magnets to the coils, for the firing angle

    These timing magnets are ceramic the same...
  22. Replies
    91
    Views
    27,820

    Hea, Here are Pics of the 3D printed window...

    Hea,

    Here are Pics of the 3D printed window motor timing wheel and hall holders / mounting bracket

    I have tryed Optical, but you have to have a timing wheel designed for it, that is adjustable...
  23. Replies
    91
    Views
    27,820

    Yaro. I would not consider Hall switches as a...

    Yaro.

    I would not consider Hall switches as a Cruder form of switching..... i consider Hall switches a far more elegant and useful form of switching compared to the reed switches, that the high...
  24. Replies
    91
    Views
    27,820

    Making a larger ZFM motor, will require the JB...

    Making a larger ZFM motor, will require the JB Ferris Wheel Circuit in a H bridge circuit configuration like the ZFM H bridge circuit is.......

    Then advance to a mulity strand per coil, muilty...
  25. Replies
    91
    Views
    27,820

    Making a larger ZFM motor, will require the JB...

    Making a larger ZFM motor, will require the JB Ferris Wheel Circuit in a H bridge circuit configuration like the ZFM H bridge circuit is.......

    Then advance to a mulity strand muilty transistor...
Results 1 to 25 of 361
Page 1 of 15 1 2 3 4