Bedini RPX Sideband Generator

* NEW * BEDINI RPX BOOK & DVD SET: BEDINI RPX


2019 ESTC ALL SEATS SOLD OUT!
PRE-REGISTER FOR THE
2020 ENERGY CONFERENCE

Monero XMR

Search:

Type: Posts; User: Robert Darrah

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. Replies
    12
    Views
    9,068

    Hi, Look in file #14 Bedini-Brandt Circuits on...

    Hi,

    Look in file #14 Bedini-Brandt Circuits on the Cejka Dvd EFTV Part #20 and there are schematics for the scalar detector. JB uses it in EFTV #11 on the Howard Johnson material and you can see...
  2. Replies
    58
    Views
    17,861

    Hi John K., I feel better reading this, as my...

    Hi John K.,

    I feel better reading this, as my heap only has 4 batteries on it. So far. :whistle: It took me about 15 cycles to ruin 2 l&g batteries with my 5 filar, and as I gained proficiency in...
  3. Replies
    159
    Views
    57,454

    Hi Tom C. I've got an 8 filar built and...

    Hi Tom C.

    I've got an 8 filar built and running per the specs on this thread, except I see a big blue cap still sitting there on the floor. Oops, better do something with it. JB said to put a...
  4. Hi, I had popped the opto out the other day to...

    Hi,

    I had popped the opto out the other day to see how high the cap would charge and it didn't fry anything, so I thought I'd use the scope to see what was happening in the primary if I...
  5. Replies
    205
    Views
    77,407

    Sticky: Hi Aaron, Thanks for looking into this. The...

    Hi Aaron,

    Thanks for looking into this. The point I want to make is if people need a 20" diameter rim and they order what is called a 20" diameter rim they will end up with one that is only 16". ...
  6. Replies
    205
    Views
    77,407

    Sticky: Hi Aaron, On pages 50 and 53 it says a 20"...

    Hi Aaron,

    On pages 50 and 53 it says a 20" bicycle wheel and the exact dimension is 22". What I've found is if you go buy a 20" bike rim it will actually measure 16 1/2". So if you want a rim...
  7. Hi bluestix, My knowledge of electronics is...

    Hi bluestix,

    My knowledge of electronics is pretty minimal, but let me see what I can do. In an ssg circuit both sides are connected electrically, which is not the case with this circuit. That's...
  8. Replies
    54
    Views
    15,589

    Hi, I did some tests with adjusting the air...

    Hi,

    I did some tests with adjusting the air gap on my 5 filar just to see what difference the gap size makes. I took 4 pieces of aluminum angle (2 on each side of the rotor) and separated them...
  9. Hi Coye, Where did you get the board from? ...

    Hi Coye,

    Where did you get the board from? Teslagenx? I've got everything together for an 8 filar now except the board, so could use a board soon.

    thanks,

    Robert
  10. Replies
    58
    Views
    17,861

    Hi John K., Thanks for all the good...

    Hi John K.,

    Thanks for all the good information. It seems like more and more I say, "Of course it doesn't work. It's new." Yet it's still a blind spot because I never would have thought new...
  11. Replies
    58
    Views
    17,861

    Hi John K. and Tom C., I remember in one post...

    Hi John K. and Tom C.,

    I remember in one post John said deep cycle batteries are the best. I see deep cycle batteries are available in the 12-15 ah range, but they are all SLABs. Could you give...
  12. Replies
    4
    Views
    2,046

    Hi, I wanted to litz the coil for my 5 filar...

    Hi,

    I wanted to litz the coil for my 5 filar but didn't want to go out to the park in the weather and stretch the wires out to do it, so I made a Q&D litzer to go with the coil winder.
    ...
  13. Replies
    159
    Views
    57,454

    Hi Tom C., Ok, thanks. So we're looking at a...

    Hi Tom C.,

    Ok, thanks. So we're looking at a space of 1.52" between the magnets for a 16" wheel. For a 17" wheel it would be 1.67", which is about an extra 5/32". The key info then would that...
  14. Replies
    159
    Views
    57,454

    Hi Tom C., When you say 16" diameter, you're...

    Hi Tom C.,

    When you say 16" diameter, you're talking about the actual size of the rim without the tire, correct? I see people selling 16" rims and they say that the actual rim size is smaller,...
  15. Replies
    54
    Views
    15,589

    Hi cald, Tom's specs are in a thread called...

    Hi cald,

    Tom's specs are in a thread called "Advancement process gone?" There aren't too many specs really, mostly the coil size. There are a number of posts about it in that thread, mostly in...
  16. Replies
    54
    Views
    15,589

    Thanks Rob and Theunis. I've got some new...

    Thanks Rob and Theunis. I've got some new batteries, so I'll go back to looking at the tuning and spacing and the little details that make all the difference.

    I picked up Free Energy Generation...
  17. Replies
    54
    Views
    15,589

    Hi, Here's an update on my 5 filar build. ...

    Hi,

    Here's an update on my 5 filar build. I've done 15 runs now and it's like watching a horror movie in slow motion. On run 1 the discharge amp hours was 14 and by run 15 it's down to 6. The...
  18. Replies
    2
    Views
    1,262

    Hi Branch, Did you check the voltage of your...

    Hi Branch,

    Did you check the voltage of your charged primary when it has a load on it? It might have something wrong internally and the voltage looks ok when there is no load on it, but then you...
  19. Replies
    39
    Views
    22,661

    Hi Branch, This takes me back to my younger...

    Hi Branch,

    This takes me back to my younger days when I played with pyramids a bit. What we would do was take 1/2" copper plumbing pipe and pack it full of quartz powder to amplify it. You could...
  20. Replies
    54
    Views
    15,589

    Hi Rob, The way I understand it is the spike...

    Hi Rob,

    The way I understand it is the spike you're not seeing in the wave is when the coil collapses and the radiant spike comes in, which explains why the battery isn't charging very high. I'm...
  21. Replies
    1
    Views
    1,029

    Hi, I was at the hardware so I picked up some...

    Hi,

    I was at the hardware so I picked up some stainless screws to show what I was talking about. I'll save a thousand words and post a pic:

    926

    They have all the little bags of stainless...
  22. Replies
    1
    Views
    1,029

    Magnet drag in the environment

    Hi,

    I wanted to make a couple of obsevations about metal surrounding the monopole. I mentioned before that a compass will deflect slightly at least a foot away from a ceramic magnet. That's with...
  23. Hi, I built one of the capacitive discharge...

    Hi,

    I built one of the capacitive discharge monopoles according to the circuit posted on this thread. I tried to get everything as close as I could to the original specs. The exceptions were I...
  24. Replies
    10
    Views
    12,551

    Sticky: Hi, I just got one of these and I want to use...

    Hi,

    I just got one of these and I want to use it to charge the primary battery for my monopole. I know you can't use a radiant charged battery as the primary, but is a battery charged by this...
  25. Replies
    54
    Views
    15,589

    Hi Rob, Sometimes when the theory doesn't work...

    Hi Rob,

    Sometimes when the theory doesn't work and the troubleshooting skills just aren't cutting it, then you're down to your last resort, which is to be a parts changer. I've done it on my car...
Results 1 to 25 of 50
Page 1 of 2 1 2