View Profile: Faraday88 - Energy Science Forum

Yesterday, 09:50 PM

Aaron Murakami replied to a thread Two Stage Mechanical Oscillator Replication in Mechanical Amplifiers

Great start! Is that SG circuit running in attraction or repulsion mode?

3 replies | 239 view(s)

Yesterday, 03:12 PM

Aaron Murakami replied to a thread 2019 Energy Science & Technology Conference in Energy Science Forum - Official

ONLY 46 SEATS AVAILABLE! - 2019 ENERGY CONFERENCE

8 replies | 6402 view(s)

04-21-2019, 08:35 PM

Aaron Murakami replied to a thread Plasma Ignition | Plasma Jet Ignition in Internal Combustion Engines

On 3/3/2019 2:27 AM, Firoz Musthafa wrote: Sure Aaron, currently I don't have the equipment to read EGT, but I will do it for you. I will see if...

1089 replies | 311542 view(s)

04-21-2019, 08:35 PM

Aaron Murakami replied to a thread Plasma Ignition | Plasma Jet Ignition in Internal Combustion Engines

On 4/7/2019 4:26 AM, Firoz Musthafa wrote: One more point I observed when I injected steam is that, when steam is introduced to engine while...

1089 replies | 311542 view(s)

04-21-2019, 08:34 PM

Aaron Murakami replied to a thread Plasma Ignition | Plasma Jet Ignition in Internal Combustion Engines

YOU HAVE TO READ THESE FEW POSTS FROM THE BOTTOM TO THE TOP TO GET THE SEQUENCE CORRECT I've been in contact with Firoz Musthafa for a while and...

1089 replies | 311542 view(s)

04-20-2019, 01:27 AM

Faraday88 replied to a thread Explicacion motor Bedini (Bedini SG) in Bedini Monopole 3 - Beginners

You are essentially explaining a 'Trunk' Current (complimentary to Branch Current) for a Vanilla Coil situation. Also, your Genny coil of the same...

1 replies | 185 view(s)

04-20-2019, 12:32 AM

Aaron Murakami replied to a thread Plasma Ignition | Plasma Jet Ignition in Internal Combustion Engines

Coil on plugs is already solved - a COP manufacturer can build them with the diodes in the potting compound to seal it up. Someone I know was having...

1089 replies | 311542 view(s)

04-17-2019, 12:29 PM

Aaron Murakami started a thread Gravity control live call - sunday april 21 noon pdst - david alzofon in Energy Science Forum - Official

GRAVITY CONTROL LIVE CALL - SUNDAY APRIL 21 NOON PDST - DAVID ALZOFON David Alzofon's father was Dr. Frederick Alzofon who personally...

0 replies | 202 view(s)

04-15-2019, 06:43 AM

Faraday88 replied to a thread Applications of Butane Gas in Resources - General

Cooking, Gas cutting, Water boiling, if cheap you can even use it for Automotive propulsion.(Internal Combustion Engine.) Rgds, Faraday88.

1 replies | 241 view(s)

04-14-2019, 01:16 PM

Aaron Murakami started a thread Starts in 2 hours in Energy Science Forum - Official

LIVE CALL COMING UP WITH ERNST WILLEM VAN DEN BERGH - TESLA'S MAGNIFYING TRANSMITTER: RECREATING TESLA'S DREAM On Sunday, April 14th at 3pm...

0 replies | 145 view(s)

04-12-2019, 11:29 PM

Faraday88 replied to a thread Charging 3 105 AH batteries with SSG in Bedini Monopole 1 - Advanced

The Dual coils allow the batteries to be charged in Parallel or in Series (Branch current) This particular set up is designed for parallel charging...

37 replies | 3951 view(s)

04-09-2019, 09:05 AM

Faraday88 replied to a thread Charging 3 105 AH batteries with SSG in Bedini Monopole 1 - Advanced

Here is My Dual monopole in action.https://youtu.be/ZgmTgCfRLVg The Dual coils allow the batteries to be charged in Parallel or in Series (Branch...

37 replies | 3951 view(s)

04-08-2019, 11:35 PM

Aaron Murakami replied to a thread Plasma Ignition | Plasma Jet Ignition in Internal Combustion Engines

Didn't you watch my Wasted Spark plasma presentation? I answer those questions. In the coil packs, they are not autotransformer coils - the...

1089 replies | 311542 view(s)

04-06-2019, 03:18 PM

Aaron Murakami replied to a thread 2019 Energy Science & Technology Conference in Energy Science Forum - Official

ONLY 63 SEATS AVAILABLE! - 2019 ENERGY CONFERENCE

8 replies | 6402 view(s)

04-06-2019, 02:17 AM

Aaron Murakami replied to a thread Plasma Ignition | Plasma Jet Ignition in Internal Combustion Engines

Is there an off the shelf CDI/MSD available or your car? Wasted spark as you can see in my presentation for my Subaru is a bit complicated. It...

1089 replies | 311542 view(s)

04-05-2019, 12:57 PM

Aaron Murakami replied to a thread Plasma Ignition | Plasma Jet Ignition in Internal Combustion Engines

Ideally, you'd do trial and error on a dyno but that does cost a bit. The plasma ignition is not only fast itself, the entire combustion process...

1089 replies | 311542 view(s)

04-04-2019, 03:27 PM

Aaron Murakami replied to a thread 2019 Energy Science & Technology Conference in Energy Science Forum - Official

ONLY 71 SEATS AVAILABLE! - 2019 ENERGY CONFERENCE

8 replies | 6402 view(s)

04-04-2019, 01:41 PM

Aaron Murakami replied to a thread ZFM Advanced Explorations in John Bedini

By larger coils, I mean overall just having a much larger build like a 12" diameter rotor.

65 replies | 15914 view(s)

04-03-2019, 09:04 PM

Faraday88 replied to a thread Currently working on Bedini Beginner in Energy Science Forum - Official

Aaron, Thanks for chiming in. Yes I Fully agreed and i'm aware of this difference but with the premise of the what Bedinstarter stated the neo...

37 replies | 2560 view(s)

04-03-2019, 02:23 PM

Aaron Murakami replied to a thread ZFM Advanced Explorations in John Bedini

I think the higher voltage experience you have might apply to a smaller motor but it may change as it is scaled up. With larger coils, the...

65 replies | 15914 view(s)

04-03-2019, 02:15 PM

Aaron Murakami replied to a thread Plasma Ignition | Plasma Jet Ignition in Internal Combustion Engines

In any case, for the plasma, I think it would be almost impossible to calculate perfectly but ballpark could be possible. That is because it is...

1089 replies | 311542 view(s)

04-03-2019, 02:13 PM

Aaron Murakami replied to a thread Currently working on Bedini Beginner in Energy Science Forum - Official

Faraday, there are TWO basic oscillation methods for the SG circuit. The first is self oscillation - the circuit is 100% identical to the SG...

37 replies | 2560 view(s)

04-02-2019, 09:58 PM

Faraday88 replied to a thread Currently working on Bedini Beginner in Energy Science Forum - Official

Hi Bradly, What do you mean 'Trigger is backward' Forced oscillation mode you cannot run a rotored SG Rgds, Faraday88.

37 replies | 2560 view(s)

04-02-2019, 02:41 AM

Faraday88 replied to a thread Currently working on Bedini Beginner in Energy Science Forum - Official

You are correct Bedinistarter, and its the same case if it is driven forced oscillation mode or Standard oscillation mode. one pointer is make all...

37 replies | 2560 view(s)

04-01-2019, 09:25 AM

Faraday88 replied to a thread Tutorial Generador Anti-Lenz (Soy parte de la LUZ) in Alternative Energy - General

I meant the same thing.. what I refered to as 'Elementary' is to say that its the simplest (only one core) form of the Kromery generator.. Rgds, ...

5 replies | 642 view(s)

03-30-2019, 11:21 PM

Faraday88 replied to a thread Currently working on Bedini Beginner in Energy Science Forum - Official

Hi, Your coil spool is wrapped with the insulation tape I need to see the exposed spool although the twist is visible at the coil ends, I need to...

37 replies | 2560 view(s)

03-30-2019, 05:42 AM

Faraday88 replied to a thread Tutorial Generador Anti-Lenz (Soy parte de la LUZ) in Alternative Energy - General

This is nothing but single ended elementary Kromery generator(... but you need to 'Magnetically' connect the other two ends like a 'C' core. Rgds, ...

5 replies | 642 view(s)

03-29-2019, 08:21 AM

Faraday88 replied to a thread Currently working on Bedini Beginner in Energy Science Forum - Official

Ok,if you have twisted the strands the twist quality matters too! so kindly post a good photo view of the coil, one way is perhaps to re-twist them...

37 replies | 2560 view(s)

03-29-2019, 02:34 AM

Faraday88 replied to a thread Currently working on Bedini Beginner in Energy Science Forum - Official

Yes that is right they all have light up together, there is imbalance in your circuit the coils have to be twisted this would atleast ensure that...

37 replies | 2560 view(s)

03-28-2019, 05:20 AM

Faraday88 replied to a thread 10 pole monopole assembly in Bedini Monopole 3 - Beginners

Neos have their place else where in the Monopole motor..think think... it takes thinking nothing else. Rgds, Faraday88.

10 replies | 1001 view(s)

Faraday88
Senior Member

Mini Statistics

More 12 Friends

techzombie

PublicAffair

min2oly

Forrest

John_Bedini

Ajay

Recent Visitors

1 Visitor Messages

Basic Information

About Faraday88

Signature

Statistics

Total Posts

Visitor Messages

General Information

12 Friends

Aaron Murakami

Ajay

Forrest

Georgey Nico

James Milner

John_Bedini

min2oly

PublicAffair

radiant

techzombie

Faraday88 Senior Member

Mini Statistics

More 12 Friends

Recent Visitors

1 Visitor Messages

Basic Information

About Faraday88

Signature

Statistics

Total Posts

Visitor Messages

General Information

12 Friends

Faraday88
Senior Member