daucupace
Junior Member

Hi Gary, Thank you for the reply. I rechecked and did reheat some solder joints but I think they were already soldered good in the first...

Hi Joster, I get 1.4 - 1.5 ohm for each power winding and 3 ohm for the trigger...seems good to me..

Hi Joster, Thanks for the quick reply. I removed the 10w and the 100ohm 2watt resistor and only the 4w potentiometer and the 100ohm 1 watt...

Hello everyone, I put the new 4watt potentiometer with the 100 ohm 2 watt resistor as shown in below picture, unfortunately it's still the same...

Hi Joster, Thank you for the suggestions. I bought this 1k 4w potentiometer: ...

Hello RS_, Thank you for the input. I did understood that it's not a good idea to run the SSG without the output battery connected. I didn't ran...

additional pictures with coil and wire descriptions.