Deuis
Senior Member

Hi Joster, :) The Kromrey sounds like a good way to go, but you will probably need a gear reduction drive for it. The Kromery is usually a...

Mike, Am sorry, had a few, saw a number of posts brief in a row and assumed it was trolling and spam. I was wrong, please consider forgiving me,...

Slick design work! The location and coil locking feature is very good. The modular assembly allows stacking of several assemblies as you have shown.

Dave, Thanks for the lead on the Uber strapping tape. Checked out the url and it appears worthy of a trial. As the rotors increase in diameter and...

When it comes to strapping tape this stuff is the best I have found and it can be picked up most anywhere. I have never thrown a magnet when using...

Another day in the continuing adventure of the 6 Pole ZFM started with mounting two opposing N-S Neo's on the rotor. Rotor was then installed to...

Part II; Bedini and Utkin Diodes https://www.youtube.com/watch?v=YRG_-98REBk&feature=youtu.be

Thanks for the concern Dennis and Aaron. The dry Neo assembly was done to check the fits and forces involved on the rotor prior to applying the...

The machine shop came through with the motor parts today. The parts completed were the Timing rotor and the 6 Pole Neo rotor. Tried a dry assembly of...

Joe - the Oscope wave should a form of square like wave, but with a 24 volt input to the two coil leads it should show +/- 24v on the scope. One...

RS I made some room.

Hi daucupace, :) In studying your photos it looks like you may have some bad solder joints, especially on the base resistors. Use a good heat sink...

Hi Jules, :) Just finishing up a small two stage mechanical oscillator build that my grandson and I started in April of this year. He took a...

Hi Julian, :) Thanks for posting your results. I admire the professionalism and dedication you bring to your experiments! Good work. :clap: I...

Joe, Welcome to the very exclusive (at this point) and very limited ZFM club that have experienced a rotor failure at high speed. Needless to...

Latest vid demonstrates that you have overcome the initial setup problems. The reed switch support and positioning assembly is well done - this...

Hey RS, Great and detailed effort in showing the inner workings of the Bedini FW. The experiment depicting the magnets' field is excellent using...