Bedini RPX Sideband Generator

* NEW * BEDINI RPX BOOK & DVD SET: BEDINI RPX


ONLY 150 118 90 2 SEATS AVAILABLE! - 2018 ENERGY CONFERENCE

Monero XMR

Tab Content
  • Deuis's Avatar
    Today, 02:32 AM
    Deuis replied to a thread Bedini 1984, 2017 style. in John Bedini
    Me too, I swapped the 200ohm out for a 600ohm and same thing. Voltage went up by about 40% and sat on about 80 degrees. I hooked a 15W x 240V...
    58 replies | 5065 view(s)
  • Deuis's Avatar
    06-16-2018, 09:46 PM
    Deuis replied to a thread Bedini 1984, 2017 style. in John Bedini
    Interesting experiment as above. Typically the 12.7V power source could only ever supply .811W to a 199 ohm resistor. After triggering, the stable...
    58 replies | 5065 view(s)
  • Deuis's Avatar
    06-16-2018, 08:32 PM
    Deuis replied to a thread Bedini 1984, 2017 style. in John Bedini
    Some Data on the standard SG with variable air gap. I started at the closest setting of 3mm then walked it out 1mm at a time until the lowest speed...
    58 replies | 5065 view(s)
  • Deuis's Avatar
    06-15-2018, 08:37 PM
    Deuis replied to a thread Bedini 1984, 2017 style. in John Bedini
    Please dont clog up this post. This is a standard SG setup with an assisted motor. 8 filar coil, 1 trigger, 7 Power. You can see the...
    58 replies | 5065 view(s)
  • Deuis's Avatar
    06-15-2018, 07:54 PM
    Deuis replied to a thread Bedini 1984, 2017 style. in John Bedini
    I have now hooked up the SG circuit to the 8 filar 18ga coil. Under power assist I can dial down to a speed where the transistors are only just...
    58 replies | 5065 view(s)
No More Results
About BobZilla

Basic Information

Statistics


Total Posts
Total Posts
880
Posts Per Day
0.43
General Information
Last Activity
12-19-2017 11:14 AM
Join Date
11-11-2012

2 Friends

  1. applied_casimir applied_casimir is offline

    Junior Member

    applied_casimir
  2. Deuis Deuis is offline

    Senior Member

    Deuis
Showing Friends 1 to 2 of 2