Bedini RPX Sideband Generator

* NEW * BEDINI RPX BOOK & DVD SET: BEDINI RPX


2019 ESTC ALL SEATS SOLD OUT!
PRE-REGISTER FOR THE 2020 ENERGY CONFERENCE

Monero XMR

  • medusa

    There is no available content written by medusa

  • Recent Article Comments Widget

  • Recent Blog Posts

  • Recent Forum Posts

    Dave Wing

    ZFM Advanced Explorations Part II

    When it comes to strapping tape this stuff is the best I have found and it can be picked up most anywhere. I have never thrown a magnet when using this

    Dave Wing Today, 01:07 AM Go to last post
    mpgmike

    Solid State Battery Charger

    I am using a PicoScope to capture the images, which I then convert to a GIF format that is compatible with this forum. I had to take a break from "helping"

    mpgmike Yesterday, 09:27 PM Go to last post
    RS_

    Solid State Battery Charger

    I am sorry ZPDM, but Mike's Schematics are correct... I would have drawn the same thing based on your first video..... and in a way, I have drawn his

    RS_ Yesterday, 07:55 PM Go to last post
    ZPDM

    Solid State Battery Charger

    Hi Mike, yes Kudos to me, you will be happy to hear it gets even better going forward!! A brief diversion or branch, you might say in the next video covering

    ZPDM Yesterday, 03:58 PM Go to last post
    mpgmike

    Solid State Battery Charger

    I suppose I should have covered this previously, but...

    In video #1 C1 = 1 uF and C2 = 100 uF. No other values were given, so I filled in

    mpgmike Yesterday, 02:57 PM Go to last post
    mpgmike

    Solid State Battery Charger

    Same as previous, but with the addition of an inductor. C1 discharging through an inductor to charge C2:

    mpgmike Yesterday, 02:47 PM Go to last post
    mpgmike

    Solid State Battery Charger

    Here is the 2nd configuration; charge Cap1, parallel diode, discharge into Cap2:


    Please note that the scaling is not necessarily

    mpgmike Yesterday, 02:18 PM Go to last post
    mpgmike

    Solid State Battery Charger

    Kudos to you, ZPDM! I'm going to try to help you out here a bit. My intent is to create a quick schematic for each of the different configurations you

    mpgmike Yesterday, 01:57 PM Go to last post
    Joster

    Joe’s ZFM Adventures

    Thanks Yaro, yes that helps!

    Here is the new 3d design Im working on that is very easily scaleable from mini to giant....

    https://youtu.be/QfidMLnRi3I

    Joster Yesterday, 01:14 PM Go to last post
    Yaro1776

    6 Pole First Spin

    Another day in the continuing adventure of the 6 Pole ZFM started with mounting two opposing N-S Neo's on the rotor. Rotor was then installed to check

    Yaro1776 Yesterday, 12:43 PM Go to last post
    ZPDM

    Solid State Battery Charger

    Part II; Bedini and Utkin Diodes
    https://www.youtube.com/watch?v=YRG_...ature=youtu.be

    ZPDM 12-09-2019, 08:42 PM Go to last post
    devon303

    String Pyramid

    Wires have been used to emulate Cheops pyramid angles apparently to good effect - sorry don't have the reference.

    devon303 12-09-2019, 08:02 AM Go to last post
    devon303

    String Pyramid

    Wires have been used to emulate Cheops pyramid angles apparently to good effect - sorry don't have the reference.

    devon303 12-09-2019, 08:01 AM Go to last post
    heysoundude

    Why?

    Hi Mike - Glad you got your power back on.
    Maybe you might work out a simpler method of Aaron's Plasma Ignition for Waste Spark Ignition? Then

    heysoundude 12-09-2019, 12:53 AM Go to last post
    Aaron Murakami

    Plasma Ignition | Plasma Jet Ignition

    I didn't know that Robert Krupa died. I corresponded with him by email a bit.

    There are the clips of the Firestorm plug with the big plasma

    Aaron Murakami 12-07-2019, 08:46 PM Go to last post
    Joster

    Ethernet CAT Cable for the Coil

    yes i second that. I have used it for both an sg bike wheel and solid state charger since i was a network tech for 10 years and it was free lol. My preference

    Joster 12-07-2019, 04:08 PM Go to last post
    mpgmike

    Plasma Ignition | Plasma Jet Ignition

    The Pulstars with the Aquapulser active didn't put out anything near a plasma spark. It acted like a CDI level spark that never quenched; it just buzzed.

    mpgmike 12-07-2019, 02:56 PM Go to last post
    Aaron Murakami

    Plasma Ignition | Plasma Jet Ignition

    I have an X60 or whatever Aquapulser unit that I got from Arvind way back after I found out some crooks filed for the patent with my circuit in it.

    Aaron Murakami 12-07-2019, 01:35 PM Go to last post
    Aaron Murakami

    Capacitive Incubation

    I did with sprouts right before the conference where I gave a presentation on it.

    The treated seeds had a higher % that sprouted than controls

    Aaron Murakami 12-07-2019, 01:23 PM Go to last post
    RS_

    Ethernet CAT Cable for the Coil

    Never used Ethernet cable.... Have used 4 and 8 strand Phone cable and just stripped off the outer insulation.... worked well enough for a test SSG,

    RS_ 12-07-2019, 09:52 AM Go to last post