* NEW * BEDINI RPX BOOK & DVD SET: BEDINI RPX
RS, looks like that meter is about $366 on Amazon prime. Is that about what you paid? https://www.amazon.com/gp/product/B0...SIN=B01GVCS160
Aaron Murakami Today, 09:49 PMThe last pic with the green mulitmeter is measuring the DC resistance of the 10 hub motors coils in series. I have not tried to analyze these measurements,
RS_ Today, 09:32 PMMore random measurements
RS_ Today, 09:18 PMI'm interested in seeing different ways to do it. I have no experience with pic chip programming
Instead of basing it on pressure, what about
Random LCR Meter pics.....
RS_ Today, 09:09 PMI did a whole presentation on it: https://emediapress.com/aaronmurakami/biohacking/
Later, I was contacted by someone who is connected to
Here are Pics of the new LCR meter measurements i took tonight on the FW Hub Motor Coils...
there are 10 coils connected in series on the hub motor
In the 1991 Guido Ebner and Heinz Schürch were granted US Patent #5,048,458; "Method of Breeding Fish". There was an equivalent New Zealand
mpgmike Today, 06:59 PMI wish I had pictures of the simple version, but here are a few of the timing controller with the hand-held programmer. First pic is of the controller.
mpgmike Today, 01:04 PMAlso, I design electronic controls for a living. I've seen a few requests for a simple electronic controller for single cylinder gasoline engines that
mpgmike Today, 09:56 AMThanks for the concern Dennis and Aaron.
The dry Neo assembly was done to check the fits and forces involved on the rotor prior to applying
Electricity went out early Monday afternoon (NE US storm) and stayed out for 75 hours. Since I couldn't work, I caught up on some reading. Started with
mpgmike Today, 01:00 AMStrapping tape works well - both Peter and John used that on top of gluing the magnets.
Aaron Murakami Yesterday, 08:52 PMYaro, Sincerely, consider bolting those in place along with the epoxy. The neos that is. regards, dennis
dennis foyil Yesterday, 06:20 PMThe machine shop came through with the motor parts today. The parts completed were the Timing rotor and the 6 Pole Neo rotor. Tried a dry assembly of
Yaro1776 Yesterday, 02:56 PMJoe - the Oscope wave should a form of square like wave, but with a 24 volt input to the two coil leads it should show +/- 24v on the scope. One scope
Yaro1776 Yesterday, 01:43 PMRS I made some room.
Dave Wing 12-04-2019, 03:58 AM
Explorations of the Bedini Ferris Wheel Motor Energizer
yep that is what i payed.... a Keithley/Tek will be $2-5K.... Top of the line.... i wish i could afford that...LOL...
RS_ Today, 09:53 PM