Announcement

Collapse
No announcement yet.

H- Wave?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • #31
    Hi forele

    Just looked at you photo's again, you should use a couple of layers of fiberglass tape on your rotor to strap those magnets in properly " just in case ! ", with expansion of the aluminium between hot and cold I just think it a good idea especially at over 1 000 rpm !

    Theunis
    Hey !
    WHAT HAVE YOU DONE WITH THE PORTION OF SOLAR ENERGY THAT WAS ALLOCATED TO YOU TODAY? !
    JUST THINK ABOUT IT . . .

    Comment


    • #32
      Hi to all,
      i started with 6 coils each 8 strand then i took one 8 strand coil and now i thought i have to beginn with the smallest possible and now i have only a bifiliar coil,wire 0.6mm for trigger and power,68m 4.7 ohm,transistor MJL21194,1 diode 1N5408,1 diode 1N4007,62 ohm baseresistor,neon and pot.I would like to get the right H-wave but mine dosn't look like the right one.Can anybody tell me where there is the mistake.So far i know is the h-wave the key and if i don't have it then i will never reach COP over one,or am i false?meine h-wave.jpg

      Comment

      Working...
      X